CUTEK® Wood Stripper

CUTEK® Wood Stripper is a powerful and user-friendly surface coating and paint stripper.

Features

• Powerful wood stripper:
  Removes old surface coatings from timber, metal, brick and masonry surfaces
• Safe and user-friendly:
  Safe to use on your DIY project, no professional experience necessary
• Smart alternative:
  Does not use dangerous chemicals like Methylene Chloride and NMP

Scope of use

• Removing paint and coatings from timber
• Removing paint and surface coatings from metal, brick and masonry surfaces.

How to apply

Before Applying

Because of the variations in coatings to be stripped, it is vital to test CUTEK® Wood Stripper BEFORE starting your project. This will help you determine how much time you will need to leave CUTEK® Wood Stripper on the timber and how much product you will need for the job.

NOTE: CUTEK® Wood Stripper may need to be applied more than once to thick paint or film form coatings with many layers.

Safety and precautions

Before you begin to Prepare and Protect your timber, note the hazards and precautions and ensure that you have obtained and know how to use the correct safety equipment as detailed in the Safety Data Sheet.

When using CUTEK® Restore, all adjacent surfaces and vegetation must be adequately protected. It is also important to be aware of the potential for wind drift into areas with cars or pedestrian traffic when rinsing. Water flush all equipment, vegetation, paths, concrete, asphalt and other adjacent surfaces before and after contact.

Coverage

Spreading rate is approximately 1 Litre of CUTEK® Wood Stripper per 3m2 of surface area to be stripped.

Note: this can vary significantly depending on the type and thickness of the paint or wood coating being removed.

Application

Apply CUTEK® Wood Stripper evenly with a brush, roller or lambswool applicator to dry wood, rubbing into the grain. Reaction time is approx. 30-60 minutes. Keep area wet and activated by applying more CUTEK® Wood Stripper or by agitating the application area with a brush, roller or lambswool applicator. CUTEK® Wood Stripper makes surfaces slippery so DO NOT walk on the application area until CUTEK® Wood Stripper has been removed.

Test periodically with a paint scraper to determine when the old coat is stripping cleanly off the timber. When this happens, the stripped surface is ready for rinsing. We suggest that you try to strip only 1 square metre first to perfect your technique.

Removal

Once CUTEK® Wood Stripper has loosened the coating, it must be power rinsed off thoroughly. For best results, power rinse with a high-pressure washer set to approximately 50 bar (750 p.s.i.) with a fan jet pattern. REMOVAL WITH A GARDEN HOSE IS NOT SUFFICIENT.

CAUTION must be used when cleaning soft timber. Reduce the pressure or adjust distance from the substrate to avoid damaging the sapwood. It is important to adjust your cleaning process as to avoid damage to the wood fibre.

Clean from the lowest point and work upwards methodically using long even strokes in the direction of the grain. DO NOT use “turbojets” on timber.

Certain types of wood surfaces may leave a raised grain effect after stripping is completed. Sanding or poly pad scrubbing may be required to smooth out this condition.

After stripping the timber, clean your wood with CUTEK® Restore to remove residual CUTEK® Wood Stripper and rejuvenate the substrate and enhance the grain. See CUTEK® Restore for instructions.

Clean Up & Disposal

Equipment may be cleaned with CUTEK® Quickclean or soap/detergent and water. All wash water, containers/contents should be disposed in accordance with local regulations